Welcome, Guest. Please login or register.


Author Topic: Open Source Scan Converter (OSSC) (Read 3737 times)

Offline heloplan

  • Newbie
  • Posts: 10
Open Source Scan Converter (OSSC)
« on: 2022.April.09. 08:24:31 »
Nemrég vásároltam egy OSSC (v1.7) scan covertert, amit egy Dell UltraSharp 2007FP (4:3, IPS) monitorral használok. Mivel ezen a kijelzőn nincs HDMI csatlakozó, ezért DVI-n keresztül megy a kép, firmware frissítés (v0.90) után a gyári beállításokat nem módosítottam, mindössze a TX mode opciót állítottam át HDMI (RGB)-ről, DVI-re. A VGA kábelt Judge készítette, jelenleg azzal használom, de van SCART kábelem is.

Alapvetően szép a kép, minimális "jitter" mellett, ezért érdeklődnék, hogy van valakinek tapasztalata OSSC-vel, esetleg meg tudná osztani az Enterprise specifikus profilját (pl. Spectrum ZX esetén ezeket a módosításokat javasolják)?



I recently purchased an OSSC (v1.7) scan coverter to use with a Dell UltraSharp 2007FP (4:3, IPS) monitor. Since this display has no HDMI connector, it is running via DVI, after firmware update (v0.90) I did not modified the factory settings, I only changed the TX mode option from HDMI (RGB) to DVI. The VGA cable was made by Judge, this is what I'm currently using, but I also have a SCART cable.

Basically the picture is nice with minimal "jitter", so I was wondering if anyone has experience with OSSC, maybe you could share the Enterprise specific profile (e.g. for Spectrum ZX these modifications are recommended)?
« Last Edit: 2022.April.12. 15:58:13 by heloplan »

Offline Judge

  • EP lover
  • *
  • Posts: 677
  • Country: hu
Re: Open Source Scan Converter (OSSC)
« Reply #1 on: 2022.April.10. 11:36:38 »
Javaslom, olvasd végig ezt a topikot .
Szerintem vannak benne információk amit használni tudsz.
Üdv.Judge

Offline heloplan

  • Newbie
  • Posts: 10
Re: Open Source Scan Converter (OSSC)
« Reply #2 on: 2022.April.12. 11:43:02 »
Köszönöm, valójában már felületesen átfutottam és John Fante-nek írtam is üzenetet, mert úgy ítéltem meg, hogy ő tud nekem segíteni, de sajnos már eladta az OSSC-jét, ettől függetlenül alaposan is át fogom olvasni a témát.
« Last Edit: 2022.April.12. 15:49:36 by heloplan »

Offline gflorez

  • EP addict
  • *
  • Posts: 3607
  • Country: es
    • Támogató Támogató
Re: Open Source Scan Converter (OSSC)
« Reply #3 on: 2022.April.12. 14:04:37 »
Sorry, only in English.

There is a cheaper alternative to OSCC: GBSControl.

It only converts to VGA, but makes a very good job as Scandoubler.

It consist on a cheap chinese RGB-VGA converter GBS-82xx with crap firmware externally controled by an ESP8266 WiFi module with custom firmware.

I have made me one for about 50€. To control it you must connect your phone or tablet to a Wifi zone and web page that is created by the Wifi module.

There are a lot of videos on Youtube about it, even comparing it to an OSCC.

https://www.youtube.com/watch?v=fmfR0XI5czI
« Last Edit: 2022.April.12. 21:35:21 by gflorez »

Offline heloplan

  • Newbie
  • Posts: 10
Re: Open Source Scan Converter (OSSC)
« Reply #4 on: 2022.April.12. 15:47:48 »
Thank you for the feedback, I have a high level of knowledge regarding the GBSControl scandoubler, but in the end I decided to use the OSSC because I might use it for other purposes in the future. I would therefore be particularly interested in the experiences of dedicated users with OSSC.

Offline gflorez

  • EP addict
  • *
  • Posts: 3607
  • Country: es
    • Támogató Támogató
Re: Open Source Scan Converter (OSSC)
« Reply #5 on: 2022.April.12. 16:02:30 »
Ok, sorry. Yes it is a bit off-topic....

I don't want to disturb.