Enterprise Forever
:UK => Hardware => Topic started by: John Fante on 2020.September.15. 21:18:39
-
I managed to recap my "new" Egyptian EP and update to EXOS 2.4 :)
The machine works but I still have a strange noise problem on the RGB signal. See here (https://www.dropbox.com/s/6olnosttoo369qp/EP64_noise.mov?dl=0).
Any suggestions how to find the source for that?
As far as I can see the components are fine but maybe something "broke" when I turned it on the fist time?
At first boot the machine was dead. Red LED on but no picture. With the help from this (https://enterpriseforever.com/hardware/ep-repair-service-)-help-with-egyptian-ep64-no-video-outputnot-strating/) thread i managed to get it going.
The 5V rail was fine but 12V was way too low which cause the TR2 to fry (maybe killed by a bad C9). I replaced TR2 and C9 and the machine came to life :) But now I have a noise problem (see video).
To cure that I then recapped the board (took a while :) ). That is finished now but the noise is still there.
Any suggestions to where I should start looking for the error?
-
A quick BUMP :)
Any suggestions would be highly appreciated :bow:
-
Just a quick idea: this board have the extra GND patch wires? These are missing from most of EP64 machines, EP128 machines come with these. Services got a instructions if any EP64 arrived to repair, also install these to the motherboard. (Somewhere I have a document talking about these)
There are two at bottom side. (https://gafz.enterpriseforever.com/Galery/Alapgep/Picture/ISSUE6-4.jpg)
And one from the ROM chip (https://gafz.enterpriseforever.com/Galery/Alapgep/Picture/ISSUE6-5.jpg) to the expansion connector. (https://gafz.enterpriseforever.com/Galery/Alapgep/Picture/ISSUE6-6.jpg)