To tell you the truth, I hope that you and gflorez will want to test new equipment as before with EnterMice

Firmware for the MCU and configuration for the CPLD is possible reprogramm directly on the board.
In addition, the MCU can be removed from the socket (PLCC44) and programmed in an external programmer.
The PCB is adapted for MCU AT89S8253 or AT90S5315. The default chip is the first.
Both of them can be programmed in the system via the SPI interface.

For programming CPLD, you need a JTAG interface and Xillinx ISE software (exactly the same thing that I used for the EnterMice project).

I would also like to, but Zozo needs to be installed.
So Zozo will test it

Isn't bad. There is one problem with the reset from the microcontroller to CPLD (active high).
I solved it using a free port in the microcontroller (after reset is always set as '1').

The second error is the lack of a resistor at the PWM output (in RC filter was only capacitor) for the LCD contrast voltage.
This could also be solved in a simple way (seen on the movie).
I do not know why, but I can not properly initialize the OLED display. For now, I do not care.
LCD displays work well (OLED theoretically should works the same).

The buses on the card works properly (despite the two-voltage power supply).

I immediately apply all the corrections to the new version of the board (ver 1.1), but for now I do not see the need to order a new version.

I should have new, corrected L-connectors this week (they are already after customs clearance).

A lot of work ahead of me.

10 Mhz Z80

From Mouser?

I have 10 pieces of this...

[ Guests cannot view attachments ]

A silly question: in case it uses any, what Z80 ports will use the Dream Turbo Card?

Thanks.

Of course the wiki..... I have to begin to translate it soon.