I am looking for a min. 2A power supply that can supply both my EP and Exdos card (with drive) so I only need one supply. I have the standard 1,3A but it is not enough to power both.

Any recommendations?

The "standard" English PSU has 2A output, while the German one has a lower output. Zozo said it on an old thread but I can't find it.

I think it is better to feed the EP+EXDOS with the original PSU(probably you will have enough with 1,3A), and the floppy drives with the additional PSU only(with +5v and +12v outputs you can connect older 5-1/4 drives).

I am using my HxC. I understood from pear that it was recommended to have a little bigger power supply than the 1,3W in the original if you power the computer through the controller.

I have not yet testet if the original 1,3W is enough. I do not yet have a the correct power cable to connect the floppy power output from the controller to the HxC. At the moment I am using an old and BIG external powersupply for the HxC. It works but I would like a more stable and smaller solution

You mean recovering the power of over 6 W from the power supply ?

The card has a standard Molex socket with +5V power supply for the FDD drive.

Aha...! I remember, you have put a bigger FlashRom in this EXDOS-Compact version. Then it is easy to put there the HxC Manager Rom.

Aha...! I remember, you have put a bigger FlashRom in this EXDOS-Compact version. Then it is easy to put there the HxC Manager Rom.

I suggested to John Fante order it is with big Flash ROM with lot of ROMs.

Sorry for messing up W and A. A mistype from many years of PC power supply usage where everything is measured in W.

I will try with the original power supply and see if it can take the load and report back.

Thank you!